Wall heating network (heaters)
The heating network is established before finishing, where there is an assembly panel in each floor, and the pipes are collected inside the panel, where the pipes run on the floor, and it is preferable that there are no obstacles that impede the flow of the pipes
Raw materials: PEX pipes 16 mm consisting of 5 layers, including the aluminum layer, and also insulated to keep the heat inside the pipes
Elbows (2 at each heater) 16 mm in diameter at the outlets of the heaters to be at the level of the wall
Pix risers 26 mm consisting of 5 layers, including an aluminum layer, and also insulated to keep the heat inside the pipes
The assembly panel contains a manifold + 26 mm elbows + vertical valves + an air vent to discharge excess pressure in the network (2 pcs) / where the 16-millimeter pipes are connected to the place of the heater and the pipes are connected with the elbow
